Photo Album: TripleSafe installation and waterproofing a basement in Lorraine, Qc
When you find that your basement is always getting wet, you need to directly check your sump pump, and see whether it is working properly and not getting clogged.
Our customer in Lorraine knew that he needed to take a look at his pump, when things started getting bad in his basement and water was filling the place.
After contacting our company, and asking for our free consultation, we confirmed him that his problem was due to his old pump and needed to be replaced with a new system.
Below you can find more details about the installation and waterproofing system we applied.
Picture of our client's old pump
This old pump was not very efficient and did not stop water from accumulating in the place.
Open sump pump
Since this old pump was open, all the moisture was getting out.
Replacing the old pump with the TripleSafe sump pump
Most sump pumps fail because of either a failed pump, a pump that can't handle high volumes of water or power failure.
The TripleSafe assures protection from all three sump pump problems.
TripleSafe importance
And if there's a power outage, your TripleSafe system will keep operating, thanks to the UltraSump battery-powered backup pump.
IceGuard installed
This accessory that is connected to the TripleSafe will prevent the water that will be evacuated outside from freezing inside the pipes.
Sump pump's discharge line
The discharge line is the main part of the sump pump. It carries out water from the sump pump to the outside of your basement.